Hello... we have an rx2800i2 using SAS SSDs, about 10 years old. The SSDs are 2.5 inch Seagate Pulsars (100GB). One of them has failed and I have replaced it with the smallest SSD I could find, a Seagate Nytro 3350 (960GB). When I try to mount the new SSD in OpenVMS, it says it is OFFLINE and I can't get past that. The command I'm using is MOU DKA200 /FOREIGN. Anybody got any helpful ideas please?
Should have mentioned, this is OpenVMS 8.4.
HP rx2800i2 and SAS SSD
-
Topic author - Newbie
- Posts: 4
- Joined: Thu May 23, 2024 10:18 am
- Reputation: 0
- Status: Offline
HP rx2800i2 and SAS SSD
Last edited by max.jarvis@se.com on Thu May 23, 2024 10:29 am, edited 1 time in total.
-
- VSI Expert
- Active Contributor
- Posts: 38
- Joined: Thu Jun 20, 2019 11:48 am
- Reputation: 0
- Status: Offline
Re: HP rx2800i2 and SAS SSD
Let's see the output from the below command procedure.
I suspect the device does not adhere to the SCSI specification the way VMS expects it.
$ TY SCSI.COM
$ set noon
$
$ SCSI_INFO :== $SYS$ETC:SCSI_INFO
$ SCSI_INFO DKA200:
$
$ anal/sys
dklog clear DKA200:
dklog start DKA200:
exit
$ init DKA200: ZZZ
$ anal/sys
dklog show DKA200:
exit
$
$ exit
I suspect the device does not adhere to the SCSI specification the way VMS expects it.
$ TY SCSI.COM
$ set noon
$
$ SCSI_INFO :== $SYS$ETC:SCSI_INFO
$ SCSI_INFO DKA200:
$
$ anal/sys
dklog clear DKA200:
dklog start DKA200:
exit
$ init DKA200: ZZZ
$ anal/sys
dklog show DKA200:
exit
$
$ exit
--
-- Rob
-- Rob