My system disk has 3 members, currently in a merge state stuck at 0% merged
Also getting console messages:
%SHAD-I-VOLPROC, DSA0: 5 Mount verification messages have been suppressed in past 370 seconds.
No disk members are being ejected from the shadow set.
Q: are writes to DSA0: still happening to all 3 members or only to the master member ?
Shadow set I/O
-
- Master
- Posts: 199
- Joined: Fri Aug 14, 2020 11:31 am
- Reputation: 0
- Status: Offline
Re: Shadow set I/O
It is my understanding, that a MERGE operation just makes sure all members are identical block-by-block. Shadowset writes should still continue to go to all valid members.
You can try to verify this by writing a big file to the shadowset and watch the 'Operations completed' with SHOW DEV/FULL for all 3 members. That count should equally increase for all 3 members. If the disk is otherwise busy, reads should be more or less equally be distributed over all 3 members.
$ ANALYZE/SYSTEM
SDA> SHOW DEV DSAx
might give you some more information. Look at the SHAD (3rd page of the display).
Volker.
You can try to verify this by writing a big file to the shadowset and watch the 'Operations completed' with SHOW DEV/FULL for all 3 members. That count should equally increase for all 3 members. If the disk is otherwise busy, reads should be more or less equally be distributed over all 3 members.
$ ANALYZE/SYSTEM
SDA> SHOW DEV DSAx
might give you some more information. Look at the SHAD (3rd page of the display).
Volker.