V9.1 OpenSSH kit install fails with PCSI-E-DNF
Posted: Tue Jul 20, 2021 5:33 pm
An issue with PCSI has been discovered on x86. If you try to install a product kit AFTER installing the V9.1 Update V1.0 kit, the install will fail with %PCSI-E-DNF, directory not found. There is a bug in PCSI recovery data handling on x86.
If you have already installed the Update V1.0 kit, to workaround the problem you can remove the recovery data with the DCL command $ PRODUCT DELETE RECOVERY_DATA .
If you have not installed the Update V1.0 kit yet you can avoid the problem by addin the /NOSAVE_RECOVERY_DATA qualifier to the $ PRODUCT INSTALL command.
-- log of observed error --
The following product will be installed to destination:
VSI X86VMS OPENSSH V8.6-1A DISK$BARNEY_V91:[VMS$COMMON.]
Portion done: 0%
%PCSI-E-DNF, directory not found
Recovery pass starting ...
Recovery pass concluded
%PCSI-E-S_OPFAIL, operation failed
%PCSIUI-E-ABORT, operation terminated due to an unrecoverable error condition
If you have already installed the Update V1.0 kit, to workaround the problem you can remove the recovery data with the DCL command $ PRODUCT DELETE RECOVERY_DATA .
If you have not installed the Update V1.0 kit yet you can avoid the problem by addin the /NOSAVE_RECOVERY_DATA qualifier to the $ PRODUCT INSTALL command.
-- log of observed error --
The following product will be installed to destination:
VSI X86VMS OPENSSH V8.6-1A DISK$BARNEY_V91:[VMS$COMMON.]
Portion done: 0%
%PCSI-E-DNF, directory not found
Recovery pass starting ...
Recovery pass concluded
%PCSI-E-S_OPFAIL, operation failed
%PCSIUI-E-ABORT, operation terminated due to an unrecoverable error condition