I notice that the release notes post-installation tasks suggest adding startup code to SYSTARTUP-VMS.COM for both using
Code: Select all
$ if f$search("sys$startup:ssl111$startup.com") .nes. ""
$ then
$ @sys$startup:ssl111$startup.com
$ endif
$ if f$search("sys$startup:ssl3$startup.com") .nes. ""
$ then
$ @sys$startup:ssl3$startup.com
$ endif
Code: Select all
%DCL-I-SUPERSEDE, previous value of SSL111$ROOT has been superseded
%DCL-I-SUPERSEDE, previous value of SSL3$ROOT has been superseded
Therefore this part of the post-installation notes would seem to be redundant - there's no need to redo this again in the site-specific startup. This should be noted in the release notes.
As an aside - I also noticed that the x86 version of SYS$STARTUP:VMS$LPBEGIN-050_STARTUP.COM for OpenVMS V9.2-1 invokes all of the sys$startup:ssl*$startup.com routines, whereas the AXP OpenVMS V8.4-2L1 version only does the legacy sys$startup:ssl$startup.com and sys$startup:ssl1$startup.com ones - so that I do need to include the SSL3 startup in the AXP's site-specific startup.
Tony