Hyper-Threading-# of Logical CPUs-Proc Error
Posted: Tue Jul 09, 2019 5:11 pm
I received a replacement rx3600 and noticed at the EFI prompt, the # of Logical CPUs was 2 instead of 4 as on my previous rx3600.
I scoured the net and found the following procedure:
https://support.hpe.com/hpsc/doc/public ... -c01060323
After running procedure no luck. Same # of logical CPUs.
I did notice that after running the procedure as follows, the # of Logical CPUs went from 2 to 4.
Shell> cpuconfig
Shell> cpuconfig threads on
Shell> reset
When system comes back up and go back into the shell, # of Logical CPUs is 4. This is in direct conflict with the link above.
The link above indicates that through
Shell> cpuconfig threads off
The # of logical CPUs increases to 4. Confusing.
But now you know.
I scoured the net and found the following procedure:
https://support.hpe.com/hpsc/doc/public ... -c01060323
After running procedure no luck. Same # of logical CPUs.
I did notice that after running the procedure as follows, the # of Logical CPUs went from 2 to 4.
Shell> cpuconfig
Shell> cpuconfig threads on
Shell> reset
When system comes back up and go back into the shell, # of Logical CPUs is 4. This is in direct conflict with the link above.
The link above indicates that through
Shell> cpuconfig threads off
The # of logical CPUs increases to 4. Confusing.
But now you know.